FIX ALL ISSUES WITH LINKSYS VELOP TROUBLESHOOTING STEPS

Linksys Velop not working? Facing multiple Linksys Velop setup issues? No worries! This Linksys Velop troubleshooting guide will helps you resolve most of your problems in no time. Although Linksys Velop is one of the most effective yet reliable mesh WiFi tools on the market, it does experience some issues during its lifespan. These issues are not permanent and can be resolved with a few troubleshooting steps.

Go through this post to learn how to resolve Linksys Velop setup issues and other common issues as well.

BASIC LINKSYS VELOP TROUBLESHOOTING STEPS 

  1. Check the power supply

If you see your Linksys Velop not working, make sure the Linksys Velop is getting an adequate power supply. Make sure the Linksys Velop is not experiencing a power outage. You can also check the power light to confirm the same.

  1. Check for possible wear & tear

Thereafter, you need to ensure that all the cables and wires running across your Linksys Velop, modem, and computer are not showing any signs of wear and tear. Also, make sure the ethernet cable connecting your Linksys Velop to the modem is firmly plugged in on both sides.

  1. Check for defects

Last but not least! Checking for some possible defects on your Linksys Velop system is of utmost importance. There could be some defects or problems in your device that may be caused because of your negligence or the manufacturer’s as well. In some cases, the Linksys Velop setup issues also disturb the whole network. In this case, you can get in touch with a professional technician.

ADVANCED LINKSYS VELOP TROUBLESHOOTING STEPS

If you still see your Linksys Velop not working properly, then proceed with this advanced troubleshooting guide. Please follow the steps below:

  1. Reboot
  • Firstly, you need to unplug your Linksys Velop system and modem from the power outlet.
  • Wait for a few minutes before plugging them back into the power outlet.
  • Now, check if the issue persists or not. If yes, go to the next section.
  1. Reset
  • If the basic Linksys Velop troubleshooting guide could not resolve the issues on your device, then you need to reset Linksys Velop to the factory default settings.
  • Press and hold the reset button on your Velop router for a few seconds.
  • After that, the Velop router will restore its factory default settings.
  1. Reconfigure
  •  Now that you have brought your device back to its original settings, you may need to reconfigure the device.
  • Seek professional help or just do it yourself by downloading the Velop app on your mobile.
  • Follow the in-app instructions to configure the device and remove any possible Linksys Velop setup issues.
  1. Firmware upgrade
  • Loging to your Linksys Velop app and go to the Menu.
  • After that, tap Network Administration and then tap Automatic Firmware Update.
  • Follow the instructions and complete the firmware upgrade on your device.

CONCLUSION

If you see your Linksys Velop not working even after performing the basic Linksys Velop troubleshooting steps, make sure you refer to the advanced guide afterward. The advanced troubleshooting guide will resolve all the Linksys Velop setup issues as well. We hope this post helped you learn how to resolve the issues on your device on your own.

If you need assistance resolving the issues on your Velop network, please feel free to reach out to us.