New Extender Setup
Reset Wifi Extender

Method of New Extender Setup

For your information, mainly there are two most effective methods to do a New extender setup which are mentioned below:

1. Web Interface Setup (Manual Method)

2. Wireless Protected Setup (WPS Button)

Now, let’s start with the web interface method first [or you can also use Mywifiext.net web address directly]

.

Netgear New Extender Setup (Web Interface)

  • First, unbox the extender carefully
  • Now, look for a suitable place for extender installation.
  • Plug the Netgear extender into the working wall outlet which provides a fluctuation-free power supply.
  • Thereafter, press the start button until the device is booted up.
  • Take a good quality and working Ethernet cable for making the connection between the extender router.
  • Power up the computer or laptop whichever you have in your home.
  • Launch the internet browser on the respective device.

Note: It is important for you to use the updated internet browser because outdated browser creates issues.

  • Access the URL of the New extender setup.
  • Enter the default URL into the address bar of the browser. (Avoid typos)
  • Press the Enter key.
  • Log in to the extender by filling in the credentials in the on-screen fields.
  • Click on the login button.
  • Now, you will see the Basic Home Screen in which you need to perform the on-screen instruction to complete the Netgear new extender setup.

This is how you can configure your new extender through the web interface method. Now, you can access Netgear_ext to enjoy the fast blazing internet. However, look forward to learning the WPS button method.

Netgear New Extender Setup (WPS Button)

Wireless protected setup is one of the best ways to configure the Netgear extender. But, you can only use this procedure in WPS authorized model. So, before performing this process make sure your device has a WPS button.

Following are the steps of the WPS button method:

  • Initially, power on your Netgear extender.
  • Now, position it near the host router.
  • Thereafter, look for the WPS button on the back panel of your repeater.
  • Push the WPS button for some time until the light blinks.
  • You need to press the same button on the host router.
  • Now, you need to wait for some time until the device is configured.
  • Once the extender is set up, you can plug it into a dead WiFi zone to enjoy the high-speed internet.

Therefore, in this manner, you can perform the Netgear extender setup through the WPS method.

New Extender Setup
Reset Wifi Extender